![]() Press the Save Template button when done.Įnd Point Manager will help you set up the Line keys for your Sangoma Phones, based on the phone family:.Review the System Admin - FTP Setup wiki for information on setting up a username and password for phones to receive their configuration files via FTP. If using FTP, you will need to set up an FTP username and password for the PBX.FTP should be used if your phones are remote, as it requires the phone to know the FTP username and password to receive the config file.You can view the port that is currently setup for HTTP in the Global Settings section we just went through above. The default HTTP port used for phone configs is port 83 but may be different on your PBX. HTTP should be used for local or remote phones and is easy to use and required no other setup.TFTP should be used when phones are local to the PBX, as it's easy to use and requires no setup.Define what Provision Server Protocol you want to use to have your phones receive their config files:.(When you install EPM it will install the latest firmware in slot 1.) See Firmware Management for more information on updating firmware for your phones in the future. For Firmware Version, pick Firmware Slot 1 from the drop-down menu. ![]() Define your Time Zone and if you want Daylight Savings time mode to be enabled.This will pull in the IP address that you entered in the Global Settings section earlier. Give the template a Name. For the Destination Address, pick either the Internal or External option.In the right nav menu, under Brands, click on Sangoma.Įither click on the New Template button at the top to create a new template, or click on the default-sangoma template name to edit the included default template. Also take note what port you have HTTP Provisioning setup on as that port needs to be accessible for your phone to receive its configrations.Define the External IP Address or FQDN that phones will connect to when not local to the PBX.Define the Internal IP Address or FQDN that phones will connect to when local to the PBX.Navigate to the Global Settings section of EPM from the right nav bar.Under the Settings section, pick EndPoint Manager.You can verify the IP Address of EPM within the EPM Global Settings: In order for EPM to be able to communicate with the phone(s) it must be configured with the same IP address as your FreePBX / PBXact system. The End-Point-Manager (EPM) module, inside FreePBX / PBXact, is responsible for auto-provisioning Sangoma Phones. If you have an un-configured out-of-box server, please start here: FreePBX Distro First Steps After Installation Verify End-Point-Manager IP Address The following information is assuming that you have already configured extension and User Manager accounts within your FreePBX / PBXact. If using FreePBX you will need to make sure your PBX is registered with the FreePBX License server to use Phone Apps or End Point Manager for Sangoma Phones for free. Requires being on FreePBX Distro or PBXact 10.13.66 release or newer
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |